8 Install the high-speed copy connect cable (callout 3). Show the user the shape of the connectors, and how the connectors match up. 9 Install the two copy processor board (CPB) protectors (callout 4) on the back of the MFP. Figure 15. Initial hardware setup (4 of 4) 10 Install the ADF output bin. 11 Open the front door and install the print cartridge. Note The print cartridge does not have a pull tab. Note The toner seal automatically rolls up when a new print cartridge is installed in the printer. The motor used to drive the OPC (imaging drum) is initialized in the reverse direction, which rolls the toner seal onto a spindle inside the print cartridge.
The noise the printer makes when this occurs is normal. 34 Chapter 2 Product requirements C8523-90921 CAUTION Make sure that the high-speed copy connect cable is installed c ced. 2 3 2 tup (3 of 4) 2 3 2 2 4 2