Operating the OmniBook XE2 Configuring the OmniBook with the BIOS Setup Utility Advanced Menu Default 2-4 Secondary Master Sets the CD-ROM drive type and various parameters. CD-ROM drive detected and set automatically. Display Device Switches between the built-in display (LCD), an external display (CRT) if attached, and both. LCD/CRT PS/2 Mouse Enables or disables an external PS/2 mouse, when one is connected. Enabled ZV Port Sets whether zoomed video function is enabled, to connect from a PC card to a VGA controller. Enabled Quiet Boot When enabled, hides summary of power-on self-test and messages during boot. Enabled System Memory Shows the system memory size.
640KB Extended Memory Shows the extended memory size. Detected automatically. Serial port Sets how the serial port is configured by the BIOS (specified or automatic). Enabled Base I/O address Sets the I/O address and interrupt. 3F8 IRQ4 IrDA port Sets how the infrared port is configured by the BIOS (specified or automatic). Disabled Mode When IrDA port is enabled, sets the hardware to support SIR (Standard IR) or FIR (Fast IR) infrared communications. (Driver installation is required.) SIR Base I/O address When IrDA port is enabled, sets the I/O address and interrupt. 2F8 IRQ3 DMA channel When Fast IR mode is enabled, sets the DMA channel.
DMA 3 Parallel Port Sets how the parallel port is configured by the BIOS (specified or automatic). Enabled Mode Sets the port to output only, bi- directional, ECP mode, or EPP mode. Bi-directional Base I/O address Sets the I/O address. 378 IRQ7 DMA channel When ECP mode is enabled, sets the DMA channel. DMA 1 Local Bus IDE Enables the primary (hard drive) and Both