Operating the OmniBook XE2 Configuring the OmniBook with the BIOS Setup Utility Security Menu Default Power (APM) Menu* Default 2-5 Adapter secondary (CD-ROM drive) controllers. Floppy disk controller Enables the floppy disk drive. Enabled User Password Is Shows if a user password is set. Clear Supervisor Password Is Shows if an supervisor password is set. Clear Set User Password Press ENTER to set, change, or clear user password. Password length can be no longer than 8 characters, 0-9, A-Z. Set Supervisor Password Press ENTER to set, change, or clear supervisor password. This password protects BIOS Setup settings.
Password on boot Sets whether a user password is required when the computer boots. Enabled Diskette access Allows access to floppy disk drive to supervisor only or user. Supervisor PM Control Disables power management, or enables it either always or when using battery power only. Battery Powered Only Power Savings Sets the combination of power management features for your usage. Maximum Battery Life Standby Timeout Sets the period of inactivity after which the computer goes from On to Standby power mode. 2 minutes Suspend Timeout Sets the period of inactivity after which the computer goes from Standby to Suspend power mode.
2 minutes Hibernate Timeout Sets whether the computer goes from Suspend to Hibernate power mode after the indicated period of inactivity. 2 hours Hard Disk Timeout Sets the period of inactivity after which the hard disk stops spinning. 1 minute Video Timeout Sets the period of hard disk inactivity after which the screen is turned off. Off Power Button Mode Sets the action of the blue power button when pressed for less than 4 seconds. Suspend Resume on Modem Ring Sets whether the system resumes from Suspend if a ring signal is received. Off