Руководство по эксплуатации CME-USB01 — интерфейс USB для приводов (EN)

2007-07-09 5011659301-SBT1 CME-USB01 USB Interface for VFD-E Series Instruction Sheet ‹ Please thoroughly read this instruction sheet before installing option cards and putting them into use. ‹ The content of this instruction sheet may be revised without prior notice. Please consult our distributors or download the most updated version at http://www.delta.com.tw/industrialautomation/. X Layout Z Specification USB Card (CME-USB01) „ Environmental Y Installation „ Make sure that the AC Motor Drive is powered off before operation. DO NOT insert or remove the card when the AC Motor Drive is powered on.

NOTE ѕ Always use this product in a clean indoor location free from dust, corrosive gas and liquid. „ Please mount the extension card as shown and fix it with the screw packed with the card. „ Inputs/Outputs [ Notes Screw torque: Maximum 2kgf-cm „ Please use shielded wires to avoid interferences and connect the shield to ground. „ USB Cable „ To avoid interference, route the extension card wires separately and as far away (at least 15cm) as possible from other control wires, motor wires and power wires, etc. Where these wires must cross each other, please make sure they are at a 90 o angle.

USB Type B to CME-USB01 USB Type A to PC NOTE „ Always use and operate this product within the limit of its specifications. ѕ Refer to Chapter 5: Parameters 9 (Group 9) in the user manual for further details. Operating -10oC to 50oC (non-condensing and not frozen) Temperature Storage -20oC to + 60oC Temperature Ambient Less than 90%RH (non-condensing) Humidity Installation Below 1000m Altitude Less than 20Hz: Maximum 9.81 m/s2 (1G); 20 ~ 50Hz: Maximum 5.88 m/s2 (0.6G) Vibration Supports 4800, 9600, 19200, 38400, 57600 bps. Baud Rate USB USB v1.1 Specification

Стр. 1