affect your system if possible. You can also POKE the problem codes directly to the printer port. Seven-bit computers cannot use the eighth pin (128). If you have a seven-bit computer and any of your graphics data numbers are larger than 127 , change the num- bers. Be sure that no other commands or carriage returns come between the graphics command and its data. See Chapter 6 or 7. Printer freezes in graphics mode. The printer expects a certain num- ber of pin patters, determined by nl and n2. It will wait patiently until the quota is full. Note that nine-pin graphics mode requires two bytes for each column of graphics. Can't get a full page in width Some systems require a WIDTH statement.
See your system docu- mentauon. Seven-bit computers are limited to width of 0-127 , 256-383 , 512-639, etc. See seven-bit graphics subsec- uon. Problems with paper feeding or irregular darkness of printing If a self-adhesive label comes off of the backing, it may stick behind the platen and cause prob- lems with paper feeding and printing. If this happens take your MPS 1000 to a qualified service person; do not attempt to remove the label yourself. Paper-out sensor Can't deactivate paper-out sensor with DIP switch 1-7 or ESCape Computer systems that monitor printer cable pin 12 will ignore both ESCape "8" and the setting of switch 1- 7. These systems will "8" . 100