Commodore MPS 1000 — Commodore MPS 1000 Dot Matrix Printer User's Manual PDF

stop the printing when no paper is in contact with the paper-out sen- sor (a small switch located be neath the platen). Certain printer cables are designed to overcome this problem, or you can tape a business card over the switch. Be sure to remove the card if you use a cut-sheet feeder, however. Beeper Error Warnings When the MPS 1000 beeper sounds, it usually indicates that the printer is out of paper. The beeper can also be sounded by any program that sends the ASCII 7 code and by certain error conditions in the printer itself. If the printer beeps and stops printing when it is not out of paper, turn the printer off and check to see if the paper is loaded correctly.

If the paper is loaded correctly, turn the printer back on and uy to print again. If the printer beeps and does not print again, take it to a quali- fied service person. Specific Computer Problems IBM-PC solutions There are two problems in using the IBM Personal Computer BASIC to drive a printer. First, the IBM-PC BASIC inserts a carriage-return/ line-feed (CR-LF) after each 80 characters you send it. Second, it adds an LF to each CR in an LPRINT statement. Here is the way to adjust the width when it is the only problem. Tell the computer that the print line is wider than 80 characters with this WIDTH statement:

WIDTH "LPTl:'',255 The 255 is a special number that prevents the computer system from inserting a CR-LF into the line, unless there's one in your program. 101