IBM Mode The parallel interface is used when the primer is in its IBM 5152 mode. Connector pin assignments and a description of respective inter- face signals are shown in Table D-2. Table D-2 Pins and Signals (parallel) D-3 Signal Pin Return Pin Signal Direc· tion Description 1 19 STROBE IN STROBE pulse to read data in. Pulse width must be more than 0.5 microseconds at the receiving terminal. 2 3 4 5 6 7 8 9 20 21 22 23 24 25 26 27 DATA1 DATA2 DATA3 DATA4 DATA5 DATA6 DATA? DATA8 IN IN IN IN IN IN IN IN These signals represent information of the 1 st to 8th bits of parallel data, respectively. Each signal is at HIGH level when data is logical 1 and LOW when it is logical 0.
10 28 ACKNLG OUT Approximately 12 microsecond pulse. LOW indicates that data has been received and that the printer is ready to accept more data. 11 29 BUSY OUT A HIGH signal indicates that the printer cannot receive data. The signal goes HIGH in the following cases: 1) During data entry. 2) During printing. 3) When off-line. 4) During printer-error state. 12 30 PE OUT A HIGH signal Indicates that the printer is out of paper. 13 - - - Pulled up to + 5 volts throug 3.3K ohm resistance. 14 - AUTO FEED '°XT IN When this signal is LOW, the paper is automatically fed 1 line after printing. (fhe signal level can be fixed to this by setting DIP switch 2·3 to ON.) 15 - NC - Unused.
16 - ov - Logic ground level. 17 - CHASSIS GND - Printer's chassis ground, which is isolated from the logic ground. Unused. Twisted-pair return signal ground level. When this level becomes LOW, the printer controller is reset to its power-ui state and the print buffer is cleared. This level is usually HIGH; its pulse width must be more than 50 microseconds at the receiving terminal. 18 - NC - 19-30 - GND - 31 - INIT IN