Table D-2, continued Figure D-3. Connector on the printer side and its pinout Notes: 1. The column heading Direction refers to the direction of signal flow as viewed from the printer. 2. Return denotes the twisted-pair return, to be connected at signal ground level. For the interface wiring, be sure to use a twisted-pair cable for each signal and to complete the connection on the return side. To prevent noise, these cables should be shielded and connected co the chassis of the host computer or the printer. 3. All interface conditions are based on TTI level. Both the rise and the fall times of each signal must be less than 0.2 microseconds. 4.
Data transfer must be carried out by observing the ACKNLG or BUSY signal. (Data transfer to this printer can be carried out only after receipt of the ACKNLG signal or when the level of the BUSY signal is LOW) 5. Under normal conditions, printer cable pins 11, 12 and 32 are acti- vated when the paper-end condition is detected. The ESCape "8" code disables pins 11 and 32, but not pin 12. Those computers that monitor pin 12 halt printing when the paper is out, making ESCape "8" ineffective. D-4 Signal Pin Return Pin Signal Dlrec· tlon Description 32 - ERROR OUT This level becomes LOW when the printer is in: 1) Paper-end state. 2) Off-line. 3) Error state. 33 - GND - Same as for pins 19·30.
34 - NC - Unused. 35 - - - Pulled up to + 5V through 3.3K ohm resistance. 36 - SLCTIN IN Data entry to the printer is possible only when this level is LOW; DIP switch 202 is set for this at the factory.