cisco Catalyst 9300 Series Switches — Enabling Multiple VLAN Registration Protocol

class AVB-SR-B-CLASS set cos 0 (set 0 for boundary & SR class B PCP value for core port) class class-default service-policy AVB-Input-Child-Policy policy-map AVB-Input-Policy-Remark-None class class-default service-policy AVB-Input-Child-Policy This following example shows hierarchical queuing policy at the egress interface:

policy-map AVB-Output-Child-Policy class VOIP-PRIORITY-QUEUE bandwidth remaining percent 30 queue-buffers ratio 10 class MULTIMEDIA-CONFERENCING-STREAMING-QUEUE bandwidth remaining percent 15 queue-limit dscp AF41 percent 80 queue-limit dscp AF31 percent 80 queue-limit dscp AF42 percent 90 queue-limit dscp AF32 percent 90 queue-buffers ratio 10 class TRANSACTIONAL-DATA-QUEUE bandwidth remaining percent 15 queue-limit dscp AF21 percent 80 queue-limit dscp AF22 percent 90 queue-buffers ratio 10 class BULK-SCAVENGER-DATA-QUEUE bandwidth remaining percent 15 queue-limit dscp AF11 percent 80 queue-limit dscp AF12 percent 90 queue-limit dscp CS1 percent 80 queue-buffers ratio 15 class class-default bandwidth remaining percent 25 queue-buffers ratio 25 policy-map AVB-Output-Policy class AVB-SR-A-CLASS priority level 1 (Shaper value based on stream registration) class AVB-SR-B-CLASS priority level 2 (Shaper value based on stream registration) class CONTROL-MGMT-QUEUE priority level 3 percent 15 class class-default bandwidth remaining percent 100 queue-buffers ratio 80 service-policy AVB-Output-Child-Policy How to Configure Multiple VLAN Registration Protocol The following sections provide configurational information about MVRP:

Enabling Multiple VLAN Registration Protocol You can enable MVRP on the switches in the topology to enable VLAN propagation using the below command. You must change VTP mode to transparent or off , before enabling dynamic vlan creation via MVRP. Note Configuring Audio Video Bridging How to Configure Multiple VLAN Registration Protocol Configuring Audio Video Bridging 12