Configuring Double Authentication To configure double authentication, perform the following steps: 1. Enable AAA by using the aaa-new model global configuration command. 2. Use the aaa authentication command to configure your network access server to use login and PPP authentication method lists, then apply those method lists to the appropriate lines or interfaces. 3. Use the aaa authorization command to configure AAA network authorization at login. 4. Configure security protocol parameters (for example, RADIUS or TACACS+). 5. Use access control list AV pairs on the security server that the user can connect to the local host only by establishing a Telnet connection.
Configuring Authentication Configuring Double Authentication Command or Action Purpose Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 aaa accounting network default start-stop radius Example: Device(config)# aaa accounting network default start-stop radius Enables AAA accounting records. Step 4 aaa accounting delay-start Example: Device(config)# aaa accounting delay-start (Optional) Delays generation of the start accounting record until the Framed-IP-Address is assigned, allowing its use in the POD packet. Step 5 aaa pod server server-key string Example: Device(config)# aaa pod server server-key xyz123 Enables POD reception.
Step 6 radius server name non-standard Example: Device(config)# radius server radser Configures a RADIUS server and enters RADIUS server configuration mode. Step 7 address {ipv4 | ipv6} hostname Example: Device(config-radius-server)# address ipv4 radius-host Configures a RADIUS host. Step 8 end Example: Device(config-radius-server)# end Exits RADIUS server configuration mode and returns to privileged EXEC mode. Configuring Authentication 26