cisco — Configuring BFD Support for IS-IS for All Interfaces

Configuring BFD Support for IS-IS This section describes the procedures for configuring BFD support for IS-IS so that IS-IS is a registered protocol with BFD and will receive forwarding path detection failure messages from BFD. There are two methods for enabling BFD support for IS-IS: • You can enable BFD for all of the interfaces on which IS-IS is supporting IPv4 routing by using the bfd all-interfaces command in router configuration mode. You can then disable BFD for one or more of those interfaces using the isis bfd disable command in interface configuration mode.

• You can enable BFD for a subset of the interfaces for which IS-IS is routing by using the isis bfd command in interface configuration mode. To configure BFD support for IS-IS, perform the steps in one of the following sections: Prerequisites • IS-IS must be running on all participating devices. • The baseline parameters for BFD sessions on the interfaces that you want to run BFD sessions to BFD neighbors over must be configured. See the "Configuring BFD Session Parameters on the Interface" section for more information. Note Output from the show bfd neighbors details command shows the configured intervals.

The output does not show intervals that were changed because hardware-offloaded BFD sessions were configured with Tx and Rx intervals that are not multiples of 50 ms. Configuring BFD Support for IS-IS for All Interfaces To configure BFD on all IS-IS interfaces that support IPv4 routing, perform the steps in this section. Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for IS-IS Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 router isis area-tag Example:

Device(config)#router isis tag1 Specifies an IS-IS process and enters router configuration mode. Configuring Bidirectional Forwarding Detection 10