Configuring Bidirectional Forwarding Detection Configuring BFD Support for IS-IS for All Interfaces Command or Action Purpose Step 4 bfd all-interfaces Example: Device(config-router)#bfd all-interfaces Enables BFD globally on all interfaces that are associated with the IS-IS routing process. Step 5 exit Example: Device(config-router)#exit (Optional) Returns the device to global configuration mode. Step 6 interface type number Example: Device(config)#interface fastethernet 6/0 (Optional) Enters interface configuration mode. Step 7 ip router isis [ tag ] Example: Device(config-if)#ip router isis tag1 (Optional) Enables support for IPv4 routing on the interface.
Step 8 isis bfd [disable] Example: Device(config-if)#isis bfd (Optional) Enables or disables BFD on a per-interface basis for one or more interfaces that are associated with the IS-IS routing process. Note You should use the disable keyword only if you had earlier enabled BFD on all the interfaces that IS-IS is associated with, using the bfd all-interfaces command in configuration mode. Step 9 end Example: Device(config-if)#end Exits interface configuration mode and returns the device to privileged EXEC mode. Step 10 show bfd neighbors [details] Example:
Device#show bfd neighbors details (Optional) Displays information that can be used to verify if the BFD neighbor is active and displays the routing protocols that BFD has registered. Step 11 show clns interface Example: Device#show clns interface (Optional) Displays information that can be used to verify if BFD for IS-IS has been enabled for a specific IS-IS interface that is associated. Configuring Bidirectional Forwarding Detection 11