Configuring BFD Support for IS-IS for One or More Interfaces To configure BFD for only one or more IS-IS interfaces, perform the steps in this section. Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for IS-IS for One or More Interfaces Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 interface type number Example: Device(config)#interface fastethernet 6/0 Enters interface configuration mode. Step 4 ip router isis [ tag ] Example:
Device(config-if)#ip router isis tag1 Enables support for IPv4 routing on the interface. Step 5 isis bfd [disable] Example: Device(config-if)#isis bfd Enables or disables BFD on a per-interface basis for one or more interfaces that are associated with the IS-IS routing process. Note You should use the disable keyword only if you enabled BFD on all the interfaces that IS-IS is associated with using the bfd all-interfaces command in router configuration mode. Step 6 end Example: Device(config-if)#end Exits interface configuration mode and returns the device to privileged EXEC mode. Step 7 show bfd neighbors [details] Example:
Device#show bfd neighbors details (Optional) Displays information that can help verify if the BFD neighbor is active and displays the routing protocols that BFD has registered. Configuring Bidirectional Forwarding Detection 12