Configuring BFD Support for OSPF This section describes the procedures for configuring BFD support for OSPF so that OSPF is a registered protocol with BFD and will receive forwarding path detection failure messages from BFD. You can either configure BFD support for OSPF globally on all interfaces or configure it selectively on one or more interfaces. There are two methods for enabling BFD support for OSPF: • You can enable BFD for all the interfaces for which OSPF is routing by using the bfd all-interfaces command in router configuration mode. You can disable BFD support on individual interfaces using the ip ospf bfd [ disable ] command in interface configuration mode.
• You can enable BFD for a subset of the interfaces for which OSPF is routing by using the ip ospf bfd command in interface configuration mode. See the following sections for tasks for configuring BFD support for OSPF: Configuring BFD Support for OSPF for All Interfaces To configure BFD for all OSPF interfaces, perform the steps in this section. If you do not want to configure BFD on all OSPF interfaces and would rather configure BFD support specifically for one or more interfaces, see the "Configuring BFD Support for OSPF for One or More Interfaces" section. Before you begin • OSPF must be running on all participating devices.
• The baseline parameters for BFD sessions on the interfaces over which you want to run BFD sessions to BFD neighbors must be configured. See the "Configuring BFD Session Parameters on the Interface" section for more information. Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for OSPF Command or Action Purpose Step 8 show clns interface Example: Device#show clns interface (Optional) Displays information that can help verify if BFD for IS-IS has been enabled for a specific IS-IS interface that is associated. Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted.
Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Configuring Bidirectional Forwarding Detection 13