cisco — Configuring BFD Support for eBGP

Configuring BFD Support for Dynamic Routing Protocols The following sections provide configurational information about BFD support for dynamic routing protocols. Configuring BFD Support for eBGP This section describes the procedure for configuring BFD support for BGP. This ensures that BGP is a registered protocol with BFD and receives forwarding path detection failure messages from BFD. Before you begin eBGP must be running on all participating routers. Configure the baseline parameters for BFD sessions on the interfaces over which you want to run BFD sessions to BFD neighbors. See the Configuring BFD Session Parameters on the Interface section for more information.

Output from the show bfd neighbors details command shows the configured intervals. Note Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for Dynamic Routing Protocols Command or Action Purpose • An interface globally or locally disables IPv4 CEF. • An interface globally or locally disables IPv6 CEF. Step 5 end Example: Device(config-if)#end Exits interface configuration mode and returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode.

Step 3 router bgp as-tag Example: Specifies a BGP process and enters router configuration mode. Configuring Bidirectional Forwarding Detection 7