Configuring BFD Support for EIGRP This section describes the procedure for configuring BFD support for EIGRP. This ensures EIGRP is a registered protocol with BFD and receives forwarding path detection failure messages from BFD. There are two methods for enabling BFD support for EIGRP: • You can enable BFD for all interfaces for which EIGRP is routing by using the bfd all-interfaces command in router configuration mode. • You can enable BFD for a subset of the interfaces for which EIGRP is routing by using the bfd interface type number command in router configuration mode. Before you begin • EIGRP must be running on all participating routers.
• Configure the baseline parameters for BFD sessions on the interfaces over which you want to run BFD sessions to BFD neighbors. See the "Configuring BFD Session Parameters on the Interface" section for more information. Output from the show bfd neighbors details command shows the configured intervals. Note Configuring Bidirectional Forwarding Detection Configuring BFD Support for EIGRP Command or Action Purpose Device(config)#router bgp tag1 Step 4 neighbor ip-address fall-over bfd Example: Device(config-router)#neighbor 172.16.10.2 fall-over bfd Enables BFD support for fallover. Step 5 end Example:
Device(config-router)#end Exits router configuration mode and returns the router to privileged EXEC mode. Step 6 show bfd neighbors [details] Example: Device#show bfd neighbors detail (Optional) Verifies that the BFD neighbor is active and displays the routing protocols that BFD has registered. Step 7 show ip bgp neighbor Example: Device#show ip bgp neighbor (Optional) Displays information about BGP and TCP connections to neighbors. Configuring Bidirectional Forwarding Detection 8