Adding an Access VFI and an EVPN Instance as Members of the VLAN of a Border VTEP To add an access VFI and an EVPN instance as members of the VLAN of a border VTEP, perform the following steps: Procedure Configuring EVPN VXLAN External Connectivity Adding an Access VFI and an EVPN Instance as Members of the VLAN of a Border VTEP Command or Action Purpose Device# configure terminal Step 3 l2vpn vfi context vfi-name Example: Device(config)# l2vpn vfi context myVFI Establishes an Layer 2 VPN VFI between two or more separate networks, and enters VFI configuration mode. Step 4 vpn id vpn-id Example: Device(config-vfi)# vpn id 1 Configures the VPN ID for the VFI.
Step 5 member ip-address encapsulation mpls Example: Device(config-vfi)# member 10.12.12.5 encapsulation mpls Specifies the device that forms a point-to-point Layer 2 VPN VFI connection. Step 6 Repeat step 5 for all devices that form a point-to-point Layer 2 VPN VFI connection. Step 7 end Example: Device(config-vfi)# end Exits VFI configuration mode and enters privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enters privileged EXEC mode. Enter password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 vlan configuration vlan-number Example:
Device(config)# vlan configuration 11 Enters VLAN feature configuration mode for the specified VLAN interface. Enter the VLAN number that is associated with the Layer 2 VNI configured in the EVPN VXLAN network. Configuring EVPN VXLAN External Connectivity 19