Procedure Configuring the NVE Interface on a VTEP To add a VNI member to the NVE interface of a VTEP, perform the following steps: Procedure Configuring EVPN VXLAN Layer 2 Overlay Network Configuring the NVE Interface on a VTEP Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface loopback-interface-id Example: Device(config)# interface Loopback0 Enters interface configuration mode for the specified Loopback interface. Step 4 ip address ipv4-address Example:
Device(config-if)# ip address 10.12.11.11 Configures the IP address for the Loopback interface. Step 5 ip pim sparse mode Example: Device(config-if)# ip pim sparse mode Enables Protocol Independent Multicast (PIM) sparse mode on the Loopback interface. Step 6 end Example: Device(config-vlan)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring EVPN VXLAN Layer 2 Overlay Network 10