Configuring the Access-Facing Interface in the VLAN on a VTEP To configure the access-facing interface in the VLAN on a VTEP, perform the following steps: Procedure Configuring the Loopback Interface on a VTEP To configure the loopback interface on a VTEP, perform the following steps: Configuring EVPN VXLAN Layer 2 Overlay Network Configuring the Access-Facing Interface in the VLAN on a VTEP Command or Action Purpose Step 4 member evpn-instance evpn-instance-id vni l2-vni-number Example: Device(config-vlan)# member evpn-instance 1 vni 10000 Adds EVPN instance as a member of the VLAN configuration. The VNI here is used as a Layer 2 VNI. Step 5 end Example:
Device(config-vlan)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-name Example: Device(config)# interface GigabitEthernet1/0/1 Enters interface configuration mode for the specified interface. Step 4 switchport access vlan vlan-id Example: Device(config-if)# switchport access vlan 11 Configures the interface as a static-access port of the specified VLAN. Interface can also be configured as a trunk interface, if required. Step 5 end Example:
Device(config-if)# end Returns to privileged EXEC mode. Configuring EVPN VXLAN Layer 2 Overlay Network 9