Configuring an EVPN Instance on the VLAN on a VTEP To configure an EVPN instance on the VLAN on a VTEP, perform the following steps: Procedure Configuring EVPN VXLAN Layer 2 Overlay Network Configuring an EVPN Instance on the VLAN on a VTEP Command or Action Purpose Step 17 re-originate route-type5 Example: Device(config-evpn-evi)# re-originate route-type5 (Optional) Enables the centralized gateway (CGW) VTEP to re-originate the route-type 2 (RT 2) host routes from a Layer 2 VTEP as route-type 5 (RT 5) network routes into a Layer 3 overlay network. Step 18 no auto-route-target Example: Device(config-evpn-evi)# no auto-route-target (Optional) Disables auto generation of route targets.
Step 19 rd rd-value Example: Device(config-evpn-evi)# rd 65000:100 (Optional) Configures a route distinguisher manually. Step 20 route-target {import | export | both} rt-value Example: Device(config-evpn-evi)# route-target both 65000:100 (Optional) Configures route targets manually. Note Configure route targets manually if the auto-generated route target values (ASN:EVI or ASN:VNI) are different between the VTEPs. Step 21 end Example: Device(config-evpn-evi)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example:
Device# configure terminal Enters global configuration mode. Step 3 vlan configuration vlan-id Example: Device(config)# vlan configuration 11 Enters VLAN feature configuration mode for the specified VLAN interface. Configuring EVPN VXLAN Layer 2 Overlay Network 8