cisco — Configuring VRF-Aware Services for FTP and TFTP

Configuring VRF-Aware Services for Traceroute Procedure Configuring VRF-Aware Services for FTP and TFTP So that FTP and TFTP are VRF-aware, you must configure some FTP/TFTP CLIs. For example, if you want to use a VRF table that is attached to an interface, say E1/0, you need to configure the ip tftp source-interface E1/0 or the ip ftp source-interface E1/0 command to inform TFTP or FTP server to use a specific routing table. In this example, the VRF table is used to look up the destination IP address. These changes are backward-compatible and do not affect existing behavior.

That is, you can use the source-interface CLI to send packets out a particular interface even if no VRF is configured on that interface. Configuring Multi-VRF CE Configuring VRF-Aware Services for Traceroute Command or Action Purpose Device(config)#logging host 10.10.1.0 vrf vpn1 Step 5 logging buffered logging buffered size debugging Example: Device(config)#logging buffered critical 6000 debugging Logs messages to an internal buffer. Step 6 logging trap debugging Example: Device(config)#logging trap debugging Limits the logging messages sent to the syslog server. Step 7 logging facility facility Example:

Device(config)#logging facility user Sends system logging messages to a logging facility. Step 8 end Example: Device(config-if)#end Returns to privileged EXEC mode. Command or Action Purpose Step 1 traceroute vrf vrf-name ipaddress Example: Device(config)#traceroute vrf vpn2 10.10.1.1 Specifies the name of a VPN VRF in which to find the destination address. Configuring Multi-VRF CE 18