Atari Games Cops — Cops TM-398 1st Printing COLOR COVERS_Page_2.jpg

Cops OPERATOR’S MANUAL & CHAPTER 3 — TROUBLESHOOTING AND MAINTENANCE Maintenance CAUTION Never lubricate the coin mechanism with oil or grease. Procedures Introduction This section describes the maintenance procedures for all of the major assemblies and components of the game. The maintenance procedures should be performed regularly. We recommend every 3—4 months. Troubleshooting Procedures You should pinpoint the cause of a malfunction by using the test procedures described in Chapter 2. Any repairs, WARNING Before performing any maintenance or repairs, please observe all of the following safety precautions:

other than minor procedures such as bulb replacement or filter cleaning, should be referred to qualified service personnel. 1. Turn the game's power off. 2. Unplug the power cord from the electrical socket. Repair Procedures 3. Secure loose clothing such as ties and long sleeves that could get caught within the game. Secure long hair. Introduction Remove all metal jewelry such as watches and necklaces that could conduct electricity from the game's power SOUICeS. performing any repairs, use the tables in the Trouble- 4. Cleaning Procedure for Coin Mechanisms This section describes the repair procedures for all of the major assemblies and components of the game.

Before shooting Procedures section to help discover the source of the problem. The Maintenance Procedures section can also be a good starting point for fixing many game problems before beginning what might be unnecessary repairs. Speakers Regular use of the coin mechanism can result in a buildup of residue and dirt. To clean the coin mechanism, perform the following steps (please refer to Figure 4-5 for detailed part information on the coin door): Each game has five speakers: two Bose speakers mounted on each side of the attraction panel, and three speak- ers mounted at the bottom of the monitor shield. The speakers provide the music and sounds for the game and self-tests.

Speaker failure can be the cause of distorted or 1. Open the upper coin door. 2. Open the gate on the door that covers the magnet. Use the blade of a screwdriver to scrape away any metal filings that have collected on the magnet. Repiacing Upper Speakers Clean the loose dust and dirt from the coin mechanism 1. Open the Cleft or right) side access panel. with a lint-free rag or a soft brush. 2. Disconnect the harness from the speaker. 4, Clean the dirt and residue from the coin path with a toothbrush. Hot, soapy water may be used to help dissolve dirt and residue. 3. Reach into the opening, and remove the two bolts securing the Bose speaker to the cabinet. 4.

Lift the Bose speaker up from the top of the game. 5. Blow out all the loose dirt, and dry the coin mechanism with compressed air. 5. Replace and reinstall the speaker in reverse order. 6. Close the gate on the door covering 3, Then close the upper coin door. no sound. To replace the speakers, perform the follow- the magnet. ing removal and installation steps: Replacing Lower Speakers 1. Remove the six screws securing the speaker grille. Remove the speaker grille by pulling it down and out; then set it aside. 3-3