CHAPTER 3 — TROUBLESHOOTING 2. AND MAINTENANCE “% Cops OPERATOR’S MANUAL Remove the four speaker mounting screws, and lift out CAUTION the speaker panel. 3. Disconnect the harness from the speaker. 4. Replace and reinstall the speaker in reverse order. Attraction Panel Light Bulb Before handling static-sensitive components, properly ground yourself to remove any static charge buildup. 6. To replace the attraction panel light bulb, follow the Re-install the game PCB set by following the previous steps in the reverse order. removal and installation steps that follow. Power Supply 1.
Remove the two screws securing the service panels on The power supply is responsible for providing power to either side of the attraction screen. Unlock the panel. all of the game assemblies that require it. Failure of the power supply may result in erratic game play or no power at all. To remove the power supply assembly, perform the following steps: 2. Attached to the wire harness you will find bayonet- type bulb holders mounted in holes. plastic holder with your thumb withdraw the holder. 3. 4. Squeeze the and forefinger and WARNING Remove the bulb from the holder by pulling it straight out. The power supply can contain high volt- Install the bulb by inserting it firmly into the holder.
Squeeze the holder as before and replace it in its hole. ages even after the power is turned off. To avoid injury, observe all of the safety precautions before working on the power supply. (Refer to the Introduction in the Maintenance Procedures section.) System Logic Assemblies This section describes the repair and maintenance pro- cedures for the major assemblies and components related to the system’s logic and electronics. This includes the 1. printed-circuit boards 2. (PCBs) and the power supply. These components are housed in a slide-out drawer underneath the rear access panel. We recommend that this procedure be performed by qualified service personnel only.
Cops Game PCB Set The Cops game PCB set is responsible for the display Unlock and remove the rear door of the cabinet. Disconnect the wiring harnesses from the power supply. 3. Unfasten the 2 screws that secure the power supply assembly to the cabinet, and remove the power supply assembly. 4, Re-install the power supply assembly by following the previous steps in the reverse order. graphics and game play. Failure of the game PCB set may result in erratic or no game play. If this is the case, repair or replace the game PCB set by following the removal and installation steps below. properly ground yourself to remove any stat- 1. ic charge buildup. Make sure the power to the game is turned off.
CAUTION Before handling static-sensitive components, Unlock the cabinet’s top rear door. 2. Remove the two Phillips-head screws that secure the rear edge of the PCB shelf to the cabinet. 3. Disconnect the harness connectors from the game PCB set. (There are 5 connectors in all.) 4, Carefully slide the shelf that holds the PCB set toward you. Shelf movement may be hindered by the harnesses. If this is the case, disconnect the harnesses. 5. Unfasten the screw and spacer that secure the game PCB set to the shelf. Remove the game PCB set. Video Display The display used is a high-impedance Hantarex Polo 33” monitor.
To repair, replace or make adjustments to this display, follow the removal and installation steps below.