Cops OPERATOR’S MANUAL WARNING High Voltage The video display contains lethal high voltages, To avoid injury, do not service this display until you observe all precautions nec- essary for working on “ CHAPTER 3 — TROUBLESHOOTING AND MAINTENANCE 3. Disconnect all of the wire harnesses from the video display. 4, Unfasten the square-drive screws that secure the light housing assembly and remove it. 5. Unfasten the square-drive screws that secure the lower glass retainer. Remove the display shield and card- high-voltage board bezels. equipment. X-Radiation This video display is designed to minimize X-radiation. To avoid possible exposure to 6. soft X-radiation, never modify the high-volt- 7.
Unfasten the 4 flat-washers and nuts that secure the video display chassis to the cabinet monitor mounting brackets. age circuitry. Remove the video display assembly from the cabinet. Due to the large size of the display, this procedure may require two people. Implosion Hazard The cathode-ray tube (CRT) may implode if struck or dropped. The shattered glass from CAUTION the tube may cause injury up to six feet away, Use care when handling the tube and when removing it from the game cabinet. Do not attempt to remove the video display without its chassis. Also, wear gloves to protect your hands from the sheet-metal edges. . Discharge the high-voltage from the cathode-ray tube (CRT).
NOTE A label adhered to the video display assem- bly shows a circuit diagram. When the power is OFF, this circuit can be used to discharge the high voltage contained in the CRT to ground. a. Secure one end of a solid, 18-gauge wire to a screwdriver with a well-insulated handle. the other end Install the new video display by following the previous steps (excluding Step 2) in their reverse order. . Unfasten the 8 square-drive screws that secure the display shield frame to the cabinet and remove them. Remove the frame. b. Secure 8. of the wire to an earth ground. 9.
If necessary, adjust the new video display’s brightness, size, centering, purity, and convergence according to the video display service manual. Laser Disc Player If the laser disc player is replaced with a new one, you must be sure to check two items: *@ The Wy i The tn two RCA RCA nshice plugs must be plugged in as follows The black cable plugs into the 2/R jack, and the red cable plugs into the 1/L jack. — e The small switches on the rear of the laser disc player must be set as follows: The 4-position (baud rate) DIP switch, toggle 4 must be on. Also the 6-position (operational function) DIP switch, must be on. toggle . 1 c.
Briefly touch the blade end of the screwdriver to the CRT anode by sliding it under the anode cap. d. Wait 2 minutes and repeat step 2c. 3-5