INTRODUCTION “ Cops OPERATOR’S MANUAL SAFETY SUMMARY The following safety precautions apply to all game operators and service personnel. Specific warnings and cautions will be found in this manual whenever they Handle the CRTs With Care. If you drop a CRT and it breaks, it may implode! Shattered glass from the implosion can fly six feet or more. apply. Use the Proper Fuses. To avoid electrical shock, use replacement fuses which are specified in the parts list WARNING Properly Ground the Game. Players may receive an electrical shock if this game is not properly grounded! To avoid electrical shock, do not plug in the game un- til it has been inspected and properly grounded.
This game should only be plugged into a grounded threewire outlet. If you have only a two-wire outlet, we recommend you hire a licensed electrician three-wire grounded outlet. to install a for this game. Replacement fuses must match those replaced in fuse type, voltage rating, and current rating. In addition, the fuse cover must be in place during game operation. CAUTION Properly Attach All Connectors. connectors Make sure that the on each printed circuit board (PCB) are AC Power Connection. Before you plug in the game, be sure that the game’s power supply can accept the AC line voltage in your location. The line voltage re- properly plugged in. The connectors are keyed to fit only one way.
If they do not slip on easily, do not force them. If you reverse a connector, it may damage your game and void your warranty. quirements Ensure the Proper AC Line Frequency. Video games are listed in the first chapter of this manual. manufactured for operation on 60 Hz line power (used Disconnect Power During Repairs. To avoid electrical shock, disconnect the game from the AC power before removing or repairing any part of the game. If you remove or repair the video display, be very careful in the United States) must not be operated in countries with 50 Hz line power (used in Europe). If a 60 Hz to avoid electrical shock.
High voltages continue to ex- machine operates on 50 Hz line power, the fluorescent line ballast transformer will overheat and cause a potential fire hazard. Check the product identification la- ist even after power is disconnected in the display cir- bel on your machine for the line frequency required. cuitry and the cathode-ray tubes (CRTs). Do not touch the internal parts of the display with your hands or with metal objects! Always discharge the high voltage from the CRTs before servicing them. Do this after you disconnect them from the power source. First, attach one end of a large, well-insulated, 18-gauge jumper wire to ground.
Then momentarily touch the free end of the grounded jumper wire to the CRT anode by sliding the wire under the anode cap. Wait two minutes and do this again. Use Only Atari Parts. To maintain the safety of your Atari game, use only Atari parts when you repair it. ABOUT NOTES, CAUTIONS, AND WARNINGS In Atari publications, notes, have the following meaning: NOTE — cautions and warnings A highlighted piece of information. CAUTION — Equipment and/or parts can be damaged or destroyed if instructions are not followed.
You will void the warranty on Atari printed-circuit boards, parts thereon, and video displays if equipment or parts are damaged or destroyed due to failure of following in- Using non-Atari parts or modifying the game circuitry structions. may be players. WARNING — Players and/or technicians can be killed or injured if instructions are not followed. dangerous, and could injure you and your Précautions de’Emploi Générales iw \™