EPSON — Cleaning the Auto Cutter (Auto Cutter Model Only)

Chapter3 Handling Cleaning the Auto Cutter (Auto Cutter Model Only) If labels, paper dust, or adhesive has adhered to the fixed blade of the auto cutter, the blade may become dull. Clean the fixed blade following the procedure below. Fixed blade 1 If paper has been loaded, remove it. ( "How to Remove Paper (For the Auto Cutter Model)" on page 66 ) 2 Turn off the printer, and unplug the power cable. 3 As shown in the figure below, scrape off adhered materials stuck to the fixed blade using a flat-blade screwdriver (blade width: 1.8 mm to 3 mm (0.07 inches to 0.12 inches)). Start scraping from each end toward the center. Keep the blade upright while cleaning the auto cutter.

Keep the blade in contact with the bottom of the paper ejection slot. 301