EPSON — A message is displayed on the operation panel.

Chapter3 Handling 317 Message Meaning Solution Information The fanfold paper is not loaded. The fanfold paper is not loaded. Load fanfold paper. ("Opening the Paper Cover" on page 49) Information Paper jam. A paper jam has occurred. Remove the jammed paper and then load paper. ("Paper is jammed" on page 329) Information The paper is not loaded correctly. Remove the paper from the top of the paper guide, close the paper cover, and then press the Pause button. The paper has not been loaded correctly. Remove the paper, and then load the paper again.

See "How to Remove Paper (For the Auto Cutter Model)" on page 66 or "How to Remove Paper (For the Peeler Model)" on page 68, and "Opening the Paper Cover" on page 49 If this error occurs during loading paper, reload the paper in accordance with the following procedure. Open the paper cover --> Remove paper from the upper paper guide --> Close the paper cover --> Press the Pause button When the home screen is displayed on the operation panel, open the cover and then load the paper. ("Loading Paper" on page 50.) If the error still occurs, check that the gap detectors are positioned correctly. ("Adjusting Gap Detector" on page 294.) Information Calibration failed. Press the OK button.

Then reload or replace the paper. Calibration is failed. Make sure that the paper loaded in the printer matches the paper detection method (gap or black mark), and reset the paper. ("Opening the Paper Cover" on page 49) If the error still occurs, the detector cannot handle the paper. Replace the paper. Information The paper has already been cut and cannot be cut. The printer failed to cut the paper. This error occurs when you press the Cut button at the position where the paper is already cut. Feed the paper by printing or pressing the Feed button to enable the Cut button. Maintenance Error The ink cartridge is not installed correctly. An ink cartridge is not installed.

Install an ink cartridge with a sufficient amount of ink remaining. ("Replacing the Ink Cartridges" on page 42) (On the home screen, an exclamation mark on the ink levels) The ink level is low. Prepare a new ink cartridge to be replaced with the low-ink-level cartridge. If you continue to use the low-ink-level cartridge, you may be required to replace it during printing. If you replace the cartridge during printing, you may see a difference in color between colors printed by the old cartridge and colors printed by the new one due to a difference in ink drying status. If it is not acceptable for you, replace the ink cartridge with a new one before starting printing.

("Replacing the Ink Cartridges" on page 42) The removed ink cartridge can be installed again and used until you are prompted to replace it.