EPSON — Cannot Print

Chapter3 Handling 324 Status Cause Solution Paper is Fed and Ejected, and an Error Occurs Media Form: Continuous Label (BlackMark), Die-cut Label (BlackMark) The paper being used differs from that of Media detection settings. Check the paper being used and Media detection settings of the printer. ("Media Source and Media Detection Settings" on page 85) The black marks do not comply with the specifications. If the reflectivity of the black marks is higher than the specified value, the black marks may not be recognizable. Infrared light is used for black mark detection, and the infrared reflectivity needs to be the specified value or lower.

Check the specifications of black mark printing, and use black marks that comply with the printer specifications. The black marks may become recognizable by adjusting the black mark detector. On the operation panel, select [Menu] - [Maintenance] - [Calibration] - [Simple Media Detect] in that order. If the problem is not resolved, carry out [Media Detect]. The sensor has failed. If operation was normal up until now, the sensor has probably failed. Request repairs.