EPSON — Cannot Print

Chapter3 Handling 323 Status Cause Solution Media Detection is Unstable Unstable conditions: • Print start position is inconsistent. • Some labels cannot be printed. • Paper is fed and ejected, and an error occurs. • A paper size error occurs even though the correct paper size is set. The position of the gap detector may be incorrect. Check that the detector adjustment tabs (light receiving and light emitting units) are in the same position and perform sensor calibration. How to align the gap detector position: ("Adjusting Gap Detector" on page 294) How to perform sensor calibration:

("Adjusting Sensitivity of the Detectors and Threshold for Detecting Labels" on page 293) Paper is Fed and Ejected, and an Error Occurs Media Form: Continuous label (without black marks) The paper being used differs from that of Media detection settings. Check the paper being used and Media detection settings of the printer. ("Media Source and Media Detection Settings" on page 85) Paper is Fed and Ejected, and an Error Occurs Media Form: Die-cut label (Gap) The paper being used differs from that of Media detection settings. Check the paper being used and Media detection settings of the printer.

("Media Source and Media Detection Settings" on page 85) The transmittance of the paper does not comply with the specifications. If the transmittance of the paper differs, gaps may not be recognizable. Infrared light is used for gap detection, and the infrared transmittance of the backing paper needs to be the specified value or higher and the infrared transmittance of the label part needs to be the specified value or lower. Check the specifications of the paper, and use paper that complies with the printer specifications. ("Paper Specifications" on page 362) The gaps may become recognizable by adjusting the label gap detector.

On the operation panel, select [Menu] - [Maintenance] - [Calibration] - [Simple Media Detect] in that order. If the problem is not resolved, carry out [Media Detect]. The sensor has failed. If operation was normal up until now, the sensor has probably failed. Request repairs.