Chapter3 Handling Cannot Print 322 Status Cause Solution Paper is Smeared or Smudged with Ink The paper being used and the Media Coating Type setting differ. Check the paper being used and the Media Coating Type setting of the printer driver. ("Printer Driver for Windows" on page 75) If foreign matter is adhered to the head, the paper may be smeared with ink. Run a print head cleaning. ("Print Head Cleaning" on page 311) If the platen vacuum is insufficient for the paper, the paper may rub against the print head and be smeared with ink. Media hold pressure might be required. Carry out the manual adjustment using the printer driver following the steps below. 1.
Display the [General] window of the printer driver. 2. Click [Advanced] in the [Media Settings] field. The advanced settings window appears. 3. Select the check box for [Media Hold Pressure] in the [Paper Adjustment] field. The manual adjustment is enabled. 4. Move the slide bar to adjust the platen vacuum. Part of print data is rimmed/Auto cut or Peeling position is Incorrect The paper being used and the media definition (size settings) do not match. If the paper and the media definition of the printer driver do not match, printing may not be at the correct position. Set the media definition correctly.
("User-Defined Paper" on page 87) Shift of print and stop position may occur depending on the paper used. Adjust the print start position using PrinterSetting. ("Position adjustment" on page 193) Status Cause Solution Print Data is Sent, But Does Not Print (Peeler Model) The label peeling detector is malfunctioning. If printing is performed at a location exposed to strong light such as direct sun rays, etc., the label peeling detector may not work properly, making it impossible to perform printing. Press the Peeler Reset button to cancel the non-printing state. Auto Paper Feeding does Not Start The position of the gap detector is not correct. Check the position of the gap detector.
("Adjusting Sensitivity of the Detectors and Threshold for Detecting Labels" on page 293) The sensor has failed. If operation was normal up until now, the sensor has probably failed. Request repairs. The printer cannot detect the paper properly. If you are using special paper, the paper may not be fed into printer automatically. Feed the paper manually. ("Feeding Paper into the Printer Manually" on page 72)