EPSON — Print Quality Problems

Chapter3 Handling 321 Status Cause Solution White or Black Banding The paper is not loaded correctly. Reload the paper. ("Opening the Paper Cover" on page 49) The paper being used and the Media Coating Type setting differ. Check the paper being used and the Media Coating Type setting of the printer driver. ("Printer Driver for Windows" on page 75) White banding or black banding can occur if the paper feeding setting is not appropriate for the paper used. Adjust the paper feed settings. The adjustment is available in [Print Head Alignment] of PrinterSetting.

("Print Head Alignment" on page 206) Unintended Top and Bottom Margins are Generated If die-cut label (without black marks) thinner than required thickness is used, the printer may not be able to correctly detect the labels and cause unintended top and bottom margins on each label. (The “top and bottom” used here means the beginning and end of labels in the paper feed direction.) Carry out [Print start position adjustment (Vertical direction)] of PrinterSetting. Enter a minus correction value to reduce the top margin, and enter a plus correction value to reduce the bottom margin.

("Position adjustment" on page 193) Printed Characters Look Blurred Blurred print may occur when the printer settings are not appropriate for the thickness of the paper. Carry out [Bi-directional Printing Adjustment] of PrinterSetting. ("Print Head Alignment" on page 206) Printed Colors Are Wrong If the printer is moved after initial charging, the specified colors may not be output (colors may be mixed) due to vibrations and impacts. Run a head cleaning and check that colors are no longer mixed. ("Print Head Cleaning" on page 311) Print position shifts The edge guide is not set along the paper edge. Check that the edge guide is properly set at the paper width position.

("Opening the Paper Cover" on page 49) The paper you are using is set at an angle. (Peeler model) Make sure that the edge of the paper is aligned with the protrusion below the peeler cover. ("Media Settings" on page 48)