Chapter3 Handling Print Quality Problems 320 Message Meaning Solution Information The paper holder unit is not Open front cover, and close completely closed. paper hold unit. the paper holder unit The paper holder unit is not e completely closed. Op un W err try Au pa Pe the paper holder unit Information The print quality may decrease because the status of nozzles cannot be detected. The ambient temperature is out of the operating temperature range. Adjust the room temperature so that it falls within 5 to 35 degrees C (41 to 95°F). The printer can’t connect to cloud service. Please check the connection status and settings with the cloud service. Please contact your administrator for details.
The printer is failing to connect to the Loftware Cloud. Contact your system administrator for more information. Status Cause Solution Horizontal White Banding The nozzles are clogging. Print the nozzle check patterns to check the nozzles for clogging. ("Test Print" on page 73) If the nozzles are clogging, run a print head cleaning. ("Print Head Cleaning" on page 311) Vertical White Banding The printed label has been back-fed. If printed labels are fed backward, the printed surface is damaged by the rollers located under the paper pressure unit.
This can occur when the print mode is set to “Stop at Cut Position” or “Stop at Peel-Off Position”, and printed labels have not been removed after each print job is finished. Select a print mode option other than “Stop at Cut Position” or “Stop at Peel-Off Position”, or remove printed labels after each print job is finished. The print mode can be configured in the [Media Definition] settings of the printer driver. ("User-Defined Paper" on page 87)