Appendix Roll paper Die-cut Label with perforation (Black Mark) Cut position Backing paper Label area 367 Black mark width Backing paper width Paper fe length length mark interval Black Label Perfor mark Black Labels between edge Side e ine baseli Gap Center of black Center of black mark detector mark detector Waste part Label width Waste pa Label length Side e baseli Waste pa Center of black mark detector Label width Label width Form Roll paper Backing paper width 25.4 to 112 mm (1 to 4.41 inches) Label width 21.4 to 108 mm (0.84 to 4.25 inches) Label length When auto cut is not used: 8 to 609.6 mm (0.31 to 24 inches) (up to 24 inches) When auto cut is used:
15 to 609.6 mm (0.59 to 24 inches) (up to 24 inches) Gap between Labels When auto cut is not used: 2 to 6 mm (0.08 to 0.24 inches) When auto cut is used:
3 to 6 mm (0.12 to 0.24 inches) Waste part on the left and right 2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R 1.5 mm (0.06 inches) or less Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 203.2 mm (8 inches) or less Winding direction Print side must be facing outside (facing inside is unusable) Black mark position Each black mark should extends at least 18.4 mm (0.72 inches) from side edge baseline.