Appendix Roll Die-cut Label (without Black Mark) Gap between pages Cut position Backing paper Label area • Labels and backing paper with holes or cutouts cannot be used. • Set the cut position to a position at least 0.7 mm (0.03 inches) away from the leading edge of the next label. • Set the start position of the first label to a position at least 1.5 mm (0.06 inches) away from the leading edge of the backing paper.
366 Backing paper width Paper f length Label Labels between Side e Gap ste part Label width Label length Label width Side e Labels between Gap ste part Form Roll paper Backing paper width 25.4 to 112 mm (1 to 4.41 inches) Label width 21.4 to 108 mm (0.84 to 4.25 inches) Label length When auto cut is not used: 8 to 609.6 mm (0.31 to 24 inches) (up to 24 inches) When auto cut is used:
15 to 609.6 mm (0.59 to 24 inches) (up to 24 inches) Gap between Labels 2 to 6 mm (0.08 to 0.24 inches) Waste part on the left and right 2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R 1.5 mm (0.06 inches) or less Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 203.2 mm (8 inches) or less Winding direction Print side must be facing outside (facing inside is unusable)