Appendix Roll paper Continuous Label (Black Mark) Black mark width Black mark interval Cut position Center of black mark detector Waste part Waste part Backing paper Label area 386 Backing paper width Paper fe Side e baseli Center of black mark detector Side e baseli Center of black mark detector length mark Black edge ine Form Roll paper Backing paper width 25.4 to 215.9 mm (1 to 8.5 inches) Label width With waste part: 25.4 to 215.9 mm (1 to 8.5 inches) Without waste part: 21.4 to 211.9 mm (0.84 to 8.34 inches) Label length - Gap between Labels - Waste part on the left and right With waste part: - Without waste part:
2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R - Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 152.4 mm (6 inches) or less Winding direction Print side must be facing outside (facing inside is unusable) Black mark position Each black mark should extends at least 18.4 mm (0.72 inches) from side edge baseline.