Appendix CW-C6500 Series (8-inch peeler model) Roll Die-cut Label (Black Mark) Black mark width Paper feed direction Black mark interval Side edge baseline Center of black mark detector Backing paper Label area 391 Backing paper width Paper length Label Labels between Side e Gap Center of black mark detector ste part Label width Waste Label length Labels between Gap ste part Center of black mark detector Label width Label width length mark Black ge e Form Roll paper Backing paper width 50.8 to 215.9 mm (2 to 8.5 inches) Label width 46.8 to 211.9 mm (1.84 to 8.34nches) Label length When peeler is not used: 8 to 609.6 mm (0.31 to 24 inches) (up to 24 inches) When peeler is used:
12.7 to 609.6 mm (0.5 to 24 inches) (up to 24 inches) Gap between Labels 2 to 6 mm (0.08 to 0.24 inches) Waste part on the left and right 2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R 1.5 mm (0.06 inches) or less Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 152.4 mm (6 inches) or less Winding direction Print side must be facing outside (facing inside is unusable)