Appendix • Labels and backing paper with holes or cutouts cannot be used. • Set the start position of the first label to a position at least 1.5 mm (0.06 inches) away from the leading edge of the backing paper. • You cannot use paper with perforation. If you use the paper, the perforation may be torn and/or a paper jam may occur. • If a blade of die had cut deep into paper, the die-cut labels become hard to be removed from the backing paper, and the peeler may fail to peel off those die-cut labels. 392 Black mark position Each black mark should extends at least 18.4 mm (0.72 inches) from side edge baseline.
Black mark width 18.4 mm (0.72 inches) or more Black mark length 4 to 25.4 mm (0.16 to 1 inch), 4 mm (0.16 inches) or more of blank space on label Black mark interval When peeler is not used: 10 to 615.6 mm (0.39 to 24.24 inches) When peeler is used: 14.7 to 615.6 mm (0.58 to 24.24 inches)