EPSON — CW-C6500 Series (8-inch peeler model)

Appendix Roll Die-cut Label (without Black Mark) Paper feed direction Side edge baseline Backing paper Label area • Labels and backing paper with holes or cutouts cannot be used. • Set the start position of the first label to a position at least 1.5 mm (0.06 inches) away from the leading edge of the backing paper. • You cannot use paper with perforation. If you use the paper, the perforation may be torn and/or a paper jam may occur. • If a blade of die had cut deep into paper, the die-cut labels become hard to be removed from the backing paper, and the peeler may fail to peel off those die-cut labels.

393 Backing paper width Paper length pages between Label Gap Labels between Side Gap ste part Label width Waste Label width Gap between pages Label length Labels between Gap ste part Form Roll paper Backing paper width 50.8 to 215.9 mm (2 to 8.5 inches) Label width 46.8 to 211.9 mm (1.84 to 8.34 inches) Label length When peeler is not used: 8 to 609.6 mm (0.31 to 24 inches) (up to 24 inches) When peeler is used:

12.7 to 609.6 mm (0.5 to 24 inches) (up to 24 inches) Gap between Labels 2 to 6 mm (0.08 to 0.24 inches) Waste part on the left and right 2 ± 0.5 mm (0.08 ± 0.02 inches) Label corner R 1.5 mm (0.06 inches) or less Paper thickness Plain Paper/Matte Paper/Synthetic/Texture Paper/Glossy Paper/Glossy Film/ High Glossy Paper 0.12 to 0.24 mm (0.005 to 0.009 inches) Roll paper core inner diameter 76.2 ± 0.5 mm (3 ± 0.02 inches) Roll paper outer diameter 152.4 mm (6 inches) or less Winding direction Print side must be facing outside (facing inside is unusable)