Chapter 3 Commands Paper out signal (output) mode setting [Format] ^S(CNA,P,c [Parameter] c [Function] This sets the paper out signal mode setting. [Initial value] 0 3 [Examples of command transmissions] The paper out signal is set to the mode that is high in the normal status, and low when there is no paper. The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNA,P,1 ^JUS ^XZ 34 Description Definition range c = Mode setting D/E/0/1/2 Value for parameter c Description D/0 Turns the paper out signal (pin 25) OFF (not output).
1 Sets the paper out signal (pin 25) as follows: Normal: High, When there is no paper: Low. E/2 Sets the paper out signal (pin 25) as follows: Normal: Low, When there is no paper: High.