Chapter 3 Commands Mode setting for pause signal (input) [Format] ^S(CNI,P,c [Parameter] c [Function] Configure the mode settings for the pause signal. [Initial value] 0 [Examples of command transmissions] 3 Set the pause signal to "Switch to the pause state when a Low signal is input for 30 msec or longer". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNI,P,1 ^JUS ^XZ 35 Description Definition range c = Mode setting 0/1 Value for parameter c Description 0 Ignore the pause signal (pin 12).
1 Set the pause signal (pin 12) to the following mode: Switch to the pause state when a Low signal is input for 30 msec or longer.