EPSON — Mode setting for re-print signal (input)

Chapter 3 Commands Mode setting for re-print signal (input) [Format] ^S(CNI,R,c [Parameter] c [Function] Configure the mode settings for the re-print signal. [Initial value] 0 [Examples of command transmissions] 3 Set the re-print signal to "Reprint labels when a Low signal is input for 30 msec or longer". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNI,R,1 ^JUS ^XZ 40 Description Definition range c = Mode setting 0/1 Value for parameter c Description 0 Ignore the re-print signal (pin 13).

1 Set the re-print signal (pin 13) to the following mode: Reprint the previously printed label when a Low signal is input for 30 msec or longer.