Chapter 3 Commands Acquisition Commands for Setting Values This section describes the commands for acquiring setting values of the printer. Acquisition commands for mode setting values for end print signal (output) [Format] ~H(CNA,B [Parameter] None [Function] Acquire the mode setting values for the end print signal. 3 [Format] ~H(CNA,A [Parameter] None [Function] Acquire the mode setting values for the print data preparation complete (print data deployed) signal. 41 Return value after executing this command Description D/0 End print signal OFF (End print signal not output) 1 End print signal (pin 18) set to Normal: High, When feeding paper: Low E/2 End print signal (pin 18) set to Normal:
Low, When feeding paper: High 3 End print signal (pin 18) set to Normal: High, When continuous printing ends and the printer stops at the predetermined position: Low for 20 msec. N/4 End print signal (pin 18) set to Normal: Low, When continuous printing ends and the printer stops at the predetermined position: High for 20 msec. D/0 End print signal OFF (End print signal not output) 1 End print signal (pin 18) set to Normal: High, When feeding paper: Low E/2 End print signal (pin 18) set to Normal: Low, When feeding paper: High 3 End print signal (pin 18) set to Normal: High, When continuous printing ends and the printer stops at the predetermined position: Low for 20 msec.
N/4 End print signal (pin 18) set to Normal: Low, When continuous printing ends and the printer stops at the predetermined position: High for 20 msec. Acquisition commands for mode setting values for data ready signal (output) Return value after executing this command Description D/0 Data ready signal (pin 23) OFF (not output). 1 Data ready signal (pin 23) set to Normal: High, When print data preparation is complete: Low E/2 Data ready signal (pin 23) set to Normal: Low, When print data preparation is complete: High