EPSON — Basic Timing for Nozzle Check and Head Cleaning

Chapter 5 Timing Basic Timing for Nozzle Check and Head Cleaning The results of the previous nozzle check are applied to the clogged nozzle detected signal. Nozzle checks are not only executed by the clogged nozzle check signal. They can also be executed automati- cally in the printer settings. For this reason, by reading the clogged nozzle detected signal (pin 24) after executing the missing dot check sig- nal, the status of the printer can be detected. In addition, please check the head maintenance signal (pin 21) to make sure that head maintenance is not in progress, before transmitting the nozzle check instruction.

The head maintenance signal (pin 21) is asserted during a nozzle check or head cleaning. The steps from nozzle check through head cleaning are described below. 1 Check the head maintenance signal to make sure that head maintenance (= nozzle check or head cleaning) is not in progress, and check the error & pause signal to make sure that an error has not occurred. 2 Transmit the clogged nozzle check to perform a nozzle check. 3 Check the head maintenance signal to make sure that head maintenance is not in progress, and then check the clogged nozzle detected signal to check for clogged nozzles.

Once 3 seconds or more have elapsed after the clogged nozzle check signal is issued, check the clogged nozzle detected signal. 4 If a clogged nozzle is discovered in step 3, transmit the head cleaning (pin 15) as nec- essary to perform head cleaning. 5 52 Q NOTE If it is unclear whether a nozzle is clogged, such as when a nozzle status unclear warning is issued, the correct value may not be obtained.