Chapter 5 Timing Basic Timing for Label Feeding The timing specifications for when the end print signal (pin 18) is set to Mode 1 or 2 (= signal is asserted when the printer feeds paper) are shown below. After the label is printed, it is moved to the cutting/specified position and remains there. After the next start print signal is issued, the printer starts printing after the backfeed operation. Note that backfeed is not included in the paper feed status. (The pin 18 end print signal is not asserted during backfeed.) When the end print signal is set to Mode 1 (= the printer feeds paper during Low) 1 After the start print signal is issued, printing starts after the backfeed operation.
2 Even if the label is peeled off, no backfeed operation is performed. 5 51 Signal Printer status Signal status Idling/ waiting for data Receiving and deploy- ing data Backfeed*1 Printing Move to cut- ting/speci- fied position*2 Idling/ waiting for data Receiving and deploy- ing data Printing Printer ready Printer not ready PRINTER READY DATA READY Data ready Not ready START PRINT END PRINT Paper feeding Otherwise