Chapter 7 Appendix Appendix Cautions for Setting Jumpers 59 WARNING • To avoid the risk of electric shocks, if disassembling or assembling this product, first remove the power supply cord and all cables from this product. • To prevent the possibility of electrical shock, do not perform maintenance, repair, or inspec- tion during a thunderstorm. • If you want to use a compressed air product, such as an air duster, for cleaning during repair and maintenance, you must never use products containing flammable gas. CAUTION • Parts on the circuit board may become hot during operation. Therefore, wait approximately 10 minutes after turning the power off before touching them.
• Wear a grounded wrist band when handling the internal circuit board to prevent damage from static electricity. • Be careful not to subject the circuit board to shock or vibration, because this may damage it. • Do not touch the circuit board or cable terminals with your hands to prevent contamination that may result in a malfunction. • Do not use an alcohol, benzine, thinner, trichloroethylene, or ketone‐based solvent to clean the parts. This type of solvent may damage the plastic and rubber parts. • As failures may be caused if liquid enters the interior of this product, do not place food or drinks on top of the case. • Wipe off any dirt with a dry or slightly moist cloth.
Be sure to remove the power cord from the outlet at this time.