Chapter 7 Appendix 5 Perform jumper settings. Pull out the connector jumper pin and insert it into the number to be set. Press with your fingers on the right side of the interface board to affix it while pulling and inserting the jumper pin. CN100 CN200 Jumper pin Once jumper settings are performed, install the covers using the following procedure. 6 Install the back cover and affix it using the screws (x 7). 62 c IMPORTANT • When shorting pins 1 and 2 on CN100, DO NOT short pins 2 and 3 on CN200. • When shorting pins 2 and 3 on CN100, DO NOT short pins 1 and 2 on CN200.
State CN100 JP setting CN200 JP setting I/O Power/SG not separated (Initial setting) 1-2 pin shorted 1-2 pin shorted I/O Power/SG separated 2-3 pin shorted 2-3 pin shorted