Chapter3 Handling Printing from the First Label When [Media Detect] is set to [Gap] or [Hole], the first label cannot be printed at the first printing after paper loading. However, even if [Media Detect] is set to [Gap] or [Hole], the following procedure will enable printing from the first label. • When you perform the following and print, auto cut is disabled. • If there is a difference between a label actually used and the settings on the printer driver, the print quality may decline. CAUTION This procedure is not necessary when [Media Detect] is set to [Black Mark] or [Off]. 1 Cut off the backing paper from 2 mm {0.08 in.} away from the top edge of the first label.
Paper feed direction 2 mm {0.08 in.} Label (first) Label 2 On the operation panel of the printer, select [Not Feed] from [Actions when Replacing Media]. [Menu] - [General Settings] - [Printer Settings] - [Print Options] - [Actions when Replacing Media] - [Not Feed] The default setting is [Feed]. 3 Specify a length of the label, and a gap between labels. ( "Media Settings" on page 65 ) 4 Load paper, and then print. For the paper loading procedure, see "Loading Paper" on page 66 . 289