Data East DX-1 — Data East DX-1 Multi Conversion Kit Installation Instructions Manual PDF

INSTALLING THE DiP SWITCHES One of the GAME most KIT important aspects game kit is making sure the erly programmed. Incorrect the system from operating. of installing processor samples these switches when er is applied, always test the system after changing any switch a DIP switches are propsettings can prevent Since the main micro- position. the main powreloading This test is accomplished by turning the Power Switch OFF and after a 10 second wait turn the Power Switch ON again. Normal tape reloading should occur. fhe LIP switches are jacent to the Volume settings are shown located Control. on Figure 9. in the RMS-& PCR, adTypical DIP switch RH COIN SELECTOR (TYP — OFF) SPECIAL PURPOSE (TYP.

6 ON. 7 & 8 OFF) LH COIN SELECTOR (TYP-QFF] TAPE DECK (MUST BE LEFT OFF] DIFFICULTY BONUS POINTS COCKTAIL/UPRIGHT NUMBER OF ROCKETS. MEN. ETC. COCKTAIL — BOTH OFF UPRIGHT — BOTH ON Figure INSERTING Install "A" side THE the 9, TAPE microcassette tape into up. Close the the top housing and proceed to the installation Module. (See Figure 10) Figure 10, of the the tape tape of deck, deck the Key