CONNECTING Turn the THE VIDEO MONITOR Main Power Switch sufficient time for the operating temperature. background picture with words DECO CASSETTE ON and wait a monitor tube to reach You should see a blue the following large sized SYSTEM printed in red. Following that, smaller white letters should WAIT UNTIL COUNTER READS 000 THEN GAME START illustrations in Trouble other colors than that an error was Shooting show (See Section). Any blue, red and whiter indicates made in connecting the video wires and should be double checked.
If there is un—decipherable video on the screen, the Vertical and/or Horizontal Hold adjustments on your monitor may have to described Should the down or Yoke may be adjusted to display the picture turned upside above. picture be stable but backwards, the wires to have instructions the Deflection to be reversed. Refer for the specific monitor to the you are using. If the position of the picture is oriented severely off the screen or an extremely unstable picture results, the Syne Signal Input to the monitor may have to be changed from its original position to the Horizontal and Vertical Negative syne position.
INSTALLING Using THE Cable Connector TAPE DECK ASSY E(V-200150-3), onto the install the the peb by looking through back of the Tape Deck Housing. Then remove ber strips from the cassette the and install the strips to into Figure 8a CN-2 of the Deck Assy. adhesive-backed deck each gular hole so as to provide for the tape deck assembly. nector Tape Edge of will be able to see rectangular hole in the the peb RMS-8 side the (See rectan- Figs. Figure rub- box an effective dust Insert the other pcb. the — foam styrofoam of You seal con— 8a 8b. & 8b)