Data East DX-1 — Data East DX-1 Multi Conversion Kit Installation Instructions Manual PDF

CONNECTING Cable C THE SPEAKER (V-200236-1) is provided with unterminated leads for connection to your speaker. Sound is generated in the RMS-8 PCB and is available at CN-1. Cable C is provided with a connector compat-— ible with CN-1. QUICK SOUND AND Adjust the Volume SYSTEM TEST Control (located to the left of CN-1) to its mechanical mid-range. Make sure that all the switches on DIP Switch 1 are in the OFF position and that there are no cables connected to the BIO-~8 PCB. Turn the Main Power Switch ON. A two-tone alarm signal should be heard in the speaker. Figure 7.

Volume CONNECTING THE VIDEO Control MONITOR Video is generated in the DSF-8 PCB and is connected to the monitor via connector CN-1. Cable D(V-200235-1) is supplied with a mating connector to Ch-1 on one end and unterminated wires on the other end (See the cable section for color coding and pin numbers). Connect the unterminated wires to your monitor inputs, being careful to ensure that all connections are made correctly and are routed to protect these video cables from the extremely high voltages that exist in monitors.